Parking lifts: mechanical safety locks

Every parking lift, whether it is an tilting parking lift, a garage parking lift, a classic two-post car lift or a four-post parking lift, has mechanical safety locks.

Lock holes of parking lifts, in order to be able to adjust the lifting height of the parking pallet, have a certain pitch, which makes it possible to adjust the lifting height of the pallet (platform) to the overall height of the garage and to the specific height of each vehicle.

The principle of operation of the mechanical lock of a parking lift is quite simple and reliable. When you activate the electro hydraulic drive, the parking platform starts rising. Upon reaching a certain height, the clamps begin to automatically fall into the engagement manholes when lifting and jump higher. When the limit switch of the upper position of the platform is triggered, the rising of the platform stops, at this moment the lock should be in the lock hole. The simultaneous occurrence of these two points is achieved by adjusting the executing devices.

Full range of 17 mechanical lock blocks start from 500mm of the bottom of the post until reach the lifting position. Each block is 70mm high and 80mm gap in between. And it will be activated when there is any failure of the hydraulic system, and hold the platform on the next locking position by the post.

Even if the hydraulic system at some point does not cope with the pressure from the parking platform with the loaded car (exceeding the maximum allowable weight of the car) or from long-term operation without the necessary maintenance of the parking lift, oil will start to leak and pressure drops in the hydraulic circuit, this will not lead to lowering of the pallet or unpleasant situations.